top of page
3D Needle Inspection 2

Uncompromising Quality & Regulatory Compliance

Building custom automation systems engineered to meet the rigorous safety, software, and regulatory standards of the medical, aerospace, and defense industries.

01

Medical & Life Sciences (cGMP & FDA 21 CFR Part 11)

Current Good Manufacturing Practices (cGMP) and FDA 21 CFR Part 11 compliance are built into our medical devices and life science system from day one. We do not just build machines; we execute full validation protocols—including Design Qualification (DQ), Factory Acceptance Testing (FAT), and strict Installation, Operational, and Performance Qualification (IQ/OQ/PQ). Every system is meticulously documented to ensure seamless integration into your cleanroom or FDA-regulated environment with audit-ready compliance records.

2 FlexSey Cells

02

Defense & Aerospace Security (ITAR)

When handling Department of Defense (DoD) and tactical aerospace contracts, data security is just as critical as physical engineering. SEYMOUR Advanced Technologies is fully ITAR (International Traffic in Arms Regulations) registered. Our facility and data infrastructure are secured to protect sensitive IP, military schematics, and proprietary manufacturing processes from concept through deployment.

6015355e-ab09-48d6-869c-563e187c1667-copied-media~2.jpg

03

Electrical Safety (UL 508A & NFPA 79)

 Every industrial control panel built by SEYMOUR Advanced Technologies  is designed and wired in-house to strict UL 508A and NFPA 79 standards. This guarantees maximum thermal efficiency, rigorous short-circuit protection, and cleanly isolated power distribution. Every wire is uniquely labeled and routed for rapid, safe field maintenance. 

UL 508A and NFPA 79 standards

04

Part 11 Data Integrity & PackML Architecture

FLexSEY HMI Ignition

In regulated manufacturing, the data matters just as much as the cycle time. Our controls engineers write standardized PLC logic using ANSI/ISA-88 (PackML) state-machine architecture with built-in FDA 21 CFR Part 11 reporting. From role-based electronic signatures and secure recipe management to immutable, time-stamped audit trails and SCADA/MES data extraction, your controls architecture arrives audit-ready out of the box.

05

Mechanical Design & FEA Validation

Precision starts at the fundamental mechanical level. All SAT mechanical CAD designs adhere to strict Geometric Dimensioning and Tolerancing (GD&T) standards (ASME Y14.5). Before steel is cut, our engineers run comprehensive Finite Element Analysis (FEA) to validate structural integrity and payload limits—and then verify final part-to-fixture alignment using 5-micron 3D laser metrology.

original_0bc435f0-0d4c-4740-a16c-d8057e35236a_Screenshot_20250208_083540_Slides_edited.jpg
Our-Process

Validation built into the architecture.

We engineer 100% validated data reporting and optical inspections directly into the cell, ensuring you meet strict cGMP, ITAR, and FDA requirements right out of the box.

Micro-sized part inspected feed and torqued.
“We can’t solve our problems with the same thinking that we used when we created them.”

Albert Einstein

Contact Team SEYMOUR

Experience today the SAT difference – where cutting-edge technology meets unparalleled project management expertise and the speed and flexibility of in-house vertical integration, supported by a team of dedicated professionals at every stage.

Technology Investigation
bottom of page